Disc brake degreaser

Bike7 Braker Cleaner disc cleaner 500ml

Braking force can be significantly reduced over time, not only because our pads and discs wear out but also because of the dirt that soaks into the pads. Regularly cleaning your pads with Bike7 Brake Cleaner will ensure you always benefit from the best possible braking force. Our brake cleaner will quickly dissolve all dirt, greasy and oily deposits from your discs and pads without leaving the slightest residue. Its rapid evaporation also guarantees safe use and it will not damage the brake piston seals or the paint on your calipers. Are the brakes on your road bike or e-bike screaming? This is most likely because fuel residue or exhaust dust has contaminated them!. A prolonged stop at a red light behind a vehicle or going out on wet surfaces after a downpour can be enough to contaminate your pads. Rest assured, with the help of Bike7 Brake Cleaner you will be able to regain efficient and quiet braking in just a few minutes. Our brakes ensure our safety, let's make sure they work optimally!

INSTRUCTIONS

In order to apply Brake Cleaner more easily, it is recommended to remove the wheels. You can also remove the pads to clean them more thoroughly, but this is not essential. Brake Cleaner is sprayed directly on both sides of the discs. Leave it on for 2-3 seconds and then wipe the disc with a clean, dry microfiber cloth.

Then spray Bike7 Brake Cleaner directly onto your brake pads. Leave it on for a few seconds and repeat the operation a second time. Then wipe your pads with a clean, dry microfiber cloth.

Pistons that do not slide well can also cause noise when braking. In this case too you can use Bike7 Brake Cleaner:

Remove the wheel and pads. Place a shim in the brake shoe so that the pistons do not come out too far when you apply the brake. Remove the shim and spray Bike7 Brake Cleaner on the pistons. Wipe the pistons with a clean cloth by sliding it across the jaw. Then apply a little bit of Bike7 Protect and wipe the whole thing again. Push back your pistons using the shim, then mount the pads and the wheel and center the assembly.

TECHNICAL INFORMATIONS

• Packaging (at 20°C): liquid.
• Flash point: < 21°C.
• Relative density (at 20°C): 0.72.
• Water solubility: moderately soluble.
• Relative vapor density: > 1.
• Shelf life: 36 months, dry, cool and protected from frost.
• For specific technical information for each package, please consult the safety data sheets.